江淮汽车 部门：客户服务部
Mechanical Part of
Engine
⑥
Dismount fastening band of fuel tank.
■
Tightening torque: 30-40N·m
⑦
Manually support the tank and carefully lower
the jack to dismount fuel tank.
Attention:
■
Make sure all connections have been
disconnected.
■
Make sure there is no interference with
vehicle.
2)
Check after dismantlement
①
Fuel tank
■
Check for impurity of fuel. If any, clean it with hot water.
■
Capacity of fuel tank: 45L
②
EVAP hose and clips
■
Check the hose for blockage, corrugation, deformation and breakage.
■
Check the clips for damage or breakage.
③
Reinforced plate and its backing plate
■
Check the surface of reinforced plate for scratch and deformation.
■
Check the backing plate for crack, material loss, deformation and breakage.
3)
Installation
Be aware of following precautions to install with steps contrary to dismantlement.
■
Firmly hold fuel supply hose to insert it.
■
Do not set the hose clamp in expansion area of fuel pipe.
■
Please refer to “Fuel Pipe Joint” for precautions of fuel pipe joint connection.
2.
Check after Installation
Check for leakage with following steps.
①
Set ignition switch at “ON” position (when engine stops), and then check the connection of fuel
pipeline for leakage.
②
Start the engine, increase its speed and recheck the connection between piping and fuel pipe of fuel
system for leakage.
Fig. 1.4.017
