江淮汽车 部门：客户服务部
Mechanical Part of
Engine
f.
Measure the pressed portion of plastic divider
at the widest point by the scale which is
printed on the plastic wire gauge bag.
Standard values: 0.02-0.04mm
Limit:0.1mm
Attention:
■
The connecting rod journal and main
journal of crankshaft should be rolled but
needn't to be machined to the reduced
size.
⑮
Flywheel
Check whether the flywheel and the signal disk are distorted or cracked.
Attention:
■
Do not disassemble the flywheel.
⑮
Crankshaft signal wheel
Check whether the crank signal wheel has
distortions, cracks and other anomalies.
Check whether the bolts are loose
3)
Assembly
①
Blow away any oil and coolant from the cylinder body, the cylinder bore and the crankcase. Remove
any foreign bodies.
Attention:
■
Use goggles to protect your eyes.
②
Install the upper and lower main bearings shells.
Attention:
■
Select the bearing shells by using the identification marks of crankshaft (See the table
Fig.1.1.065
Fig.1.1.066
Plastic Wire
Gauge
Round-angle Rolling Area
Fig.1.1.067
