16
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing properly damage, personal injury or loss of life.
A. This appliance is equipped with an
ignition device which automatically lights
the pilot. Do not try to light the pilot by
hand.
B. BEFORE OPERATING smell all around
the appliance gas area. Be sure to smell
next to the floor because some gas is
heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do
not use any phone in your building.
•
Immediately call your gas supplier
from a neighbor’s phone. Follow
the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to turn the gas control knob.
Never use tools. If the knob will not push in or turn
by hand, do not try to repair it, call a qualified
service technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information
above on this label.
2. Press the power button to the “OFF”
position or set the thermostat to the
lowest setting on the transmitter.
3. Turn off all electric power to the
appliance.
4. This appliance is equipped with an
ignition device which automatically
lights the pilot. Do not try to light the
pilot by hand.
5. Turn off all electric power to the
appliance.
6. Close the main gas valve.
(Perpendicular to pipe, 1/4 of turn)
7. Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP!
Follow “B” in the safety information above
on this label. If you do not smell gas, go to next
step.
8. Open the main gas valve. (Parallel to pipe, 1/4
of turn)
9. Turn on all electric power to the appliance.
10. Close control access panel
11. Press the power button to the “ON” position or
set the thermostat to desired setting on the
transmitter
12. If the appliance will not operate, follow the
instructions “To Turn off Gas to Appliance” and
call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the
appliance if service is to be performed.
3. Open control access panel
4. Put the battery holder switch to the
“OFF” position.
5. Close
the
main
gas
valve.
(Perpendicular to pipe, 1/4 of turn)
6. Close control access panel
Summary of Contents for suroit RGV-25
