Izon qNano, User Manual, Page: 7 / 56

Place the qNano in the recessed area of the base plate on the VPM. Connect
the VPM-PM2 and PM2-Fluid Cell tubing by pushing the tubing over the
correct barb and screwing the knurled collar on to be finger tight. DO NOT
use tools for this operation as there is a risk of damaging the equipment. The
correct tubing layout is outlined below:
Check that the fluid cell is connected to the system with the SMA cable
screwed in properly by gently pulling the entire fluid cell assembly upwards.
Once this has been ensured, click the fluid cell back into place by pushing down
firmly in the correct orientation.
Powering Your Instrument
— Plug into Earth Grounded Protected Outlets ONLY.
— Make sure the power supply box is positioned away from fluids.
— To prevent heat build-up, do not cover the power-supply box.
— Position unit so it can easily and quickly be disconnected from
mains power.
This instrument has a universal input range and will operate from a nominal
115 V or 230 V mains supply without adjustment. Check that the local supply
meets the AC Input requirement given in the Specification.
Izon Instruments are only to be operated with Izon supplied leads and power
supplies. Failure to use the correct power supply may result in
invalid operation.
Do not place the power supply or operating computer in a position where it
can come into contact with spills or moisture. Make sure the power supply is
placed away and to the rear of the instrument to avoid spills during operation.
7 www.izon.com