IXXAT FlexRay CCM/ FRC-EP150, Hardware Manual

Page: 13 / 33

Copyright IXXAT Automation GmbH
FlexRay CCM Manual, Version 2.4
Connections
13
Pin Signal
1
2
3
4 5
6
7
8
1 CAN3/4-Low
2 CAN1/2-low
3, 6 Ground (CAN)
4 CAN3/4-High
5 Reserved
7 CAN1/2-high
8 CAN VBAT
Table 3-4: Pin assignment of the CAN connector
No bus terminal resistor is integrated for high-speed CAN ISO 11898-2. If a bus
terminal resistor is required, it must be connected to the cable or connector. Fle-
xRay instrument leads with integrated terminal resistor are available as accesso-
ries.
The two CAN busses CAN1/3 and CAN2/4 are isolated galvanically from each
other and from all other interfaces.
3.1.4 Power connector (6 - 50 V DC)
The FlexRay CCM is supplied with direct current voltage of 6 V to 50 V. The
power supply input is protected against pole reversal and overvoltage.
Pin Signal
1
2
1 Supply v
2 Ground
Table 3-5: Pin assignment of the power connector
Use the appropriate power supply cable for the device. This is also available sepa-
rately as an accessory.