IWILL UPX, User Manual, Page: 70 / 78

3-6
WARNING
For your own protection, be sure your have a Crisis Recovery Diskette
ready to use before excuting Phlash.
Command Line Mode
Use this mode to update or replace your current BIOS. To execute Phlash in
this mode, move to the directory into which you have installed Phoenix Phlash
and type the following:
Phlash
Phoenix Phlash will automatically update or replace the current BIOS with the
one which your OEM or dealer supplies you.
Phlash may fail if your system is using memory managers, in which case the
utility displays the following message:
Cannot flash when memory managers are present.
If you see this message after you execute Phlash, you must disable the
memory manager on your system. To do so, follow the instructions in the
following sections.
Disabling Memory Managers
To avoid failure when flashing, you must disable the memory managers that
load from CONFIG.SYS and AUTOEXEC.BAT. There are two recommended
procedures for disabling the memory managers. One consists of pressing the
<F5> key (only if you are using DOS 5.0 or above), and the other requires the
creation of a boot diskette.
DOS 5.0 (or later version)
For DOS 5.0 and later, follow the two steps below to disable any memory
managers on your system. If you are not using at least DOS 5.0, then you
BIOS Utility