IWILL UPX, User Manual, Page: 25 / 78

Hardware Installation
3. Primary/Secondary IDE connectors (ATA-133 IDE connectors (Two
40-pin IDE)
The connectors support the provided 80-wire 40-pin IDE hard disk ribbon
cable. After connecting the single end to the board, connect the two plugs
at the other end to your hard disk(s). If you install two hard disks in the
same cable, you must configure the second drive to Slave mode by setting
its jumper accordingly. Please refer to the documentation of your hard disk
for the jumper settings. BIOS now support IDE HDD or IDE CD-ROM boot
up (Pin 20 is removed to prevent inserting in the wrong orientation when
using ribbon cables with pin 20 plugged).
1-11
P in 1
P in 1
UPX Floppy Connectors
UPX IDE Connectors