IWILL UPX, User Manual, Page: 46 / 78

2-10
There is one IDE connector for each adapter on your machine, usually labeled
"Primary IDE" and "Secondary IDE." There are usually two connectors on
each ribbon cable attached to each IDE connector. When you have connected
two drives to these connectors, the one on the end of the cable is the Master.
If you need to change your drive settings, selecting one of the Master or Slave
drives on the Main Menu displays a sub-menu like this:
PhoenixBIOS Setup Utility
Main
Primary Master Item Specific Help
Type: [
Auto ]
Multi Sector Transfer ; [Disable]
LBA Mode Control: [Disable]
32-bit I/O: [Disable]
Transfer Mode: [Auto]
Ultra DMA Mode: [Disable]
Select the drive type of
the fixed disk installed in
your system. If type User
is selected, Cylinders,
Heads, and Sectors can
be edited directly.
Auto attempts to
automatically detect the
drive type for drives that
comply with ANSI
specifications.
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit ↔ Select Menu Enter Select Sub-Menu F10 Save and Exit
Use the legend keys listed on the bottom to make your selections and exit to
the Main Menu. Use the following chart to configure the hard disk.
BIOS Setup