HU
EN
63
Main
display
Second
display
Description
Causes/Action
real cur- rent
Welding porosity, spatters and bad welding performances
1) Wrong gas selection for the kind of wire used, check the gas selection in the side panel.
2) Bad gas protection due to low input gas pressure, check the gas
fl
ow trough the command gas
purge
3) Gas leakage in the connection to the torch or inside the torch. Gas nozzle must be cleaned or changed.
4) Gas valve is not working. Check the gas used according to the problem selection in the side panel of the wire feeder.
5) Check leakage of the gas, starting from the pressure reducer of the gas bottle to the torch connector of the wire feeder.
6) Check the torch, the binzel connector must have the ""O"" ring in the shaft of the input gas,
if the torch liner is in te
fl
on control that the proper gasket is used.
real cur- rent
Voltage or current wrong value, bad welding perfor- mances, the arc shut off often, Must be used heavy cor- rections of the arc length, adjustment of inductance seems have no effect."
1) Wrong program setting in wire and material, control the selected program in the side panel.
2) Torch problems, control the state of the liner and the tip.
3) Bad condition of connections, control the state of the torch connection, interconnecting cable.
4) Control circuit problems, please ask to service center.
-
Welding mode selection is not working: It is not possible to move from the modality selection to change in STICK or TIG or ARC GOUGING
Shut off and switch on the machine, if the alarm comes again, please ask to the service center.
Summary of Contents for DYNAMIG 560
