iWeld DYNAMIG 560, User Manual

Page: 179 / 196

HU
EN
51
6. STICK/MMA Welding
6.1 Connection Diagram
The power source could be connected with one knob remote control device (RC 101), to set the welding current.
Remote Control
6.2 Welding Operation
NOTE
Before welding operation, the operators should inspect the equipment components and con
fi rm they are in nor-
mal condition.
Step 1 Connect the power plug to the socket.
You must ground the earth wire in the power supply cable.
Step 2 Turn on the main switch.
Step 3 Select the STICK/MMA mode by pressing the button " .
There are two modes under STICK/MMA welding, manual and synergy mode.
•
Manual mode: Turn the main knob to set the value of current, hot start and arc force based on the type and
diameter of the electrode, thickness of workpiece and the welding position.
• Synergic mode: Select the type of electrode by pressing the button " ". Then set the current accord-
ing to the diameter of the electrode, thickness of workpiece and welding position.
The STICK/MMA welding process can weld steel, stainless steel, carbon steel, aluminum, etc. with 5 types of elec-
trode, 6013/ RUTILE, 7018/ BASIC, 6010/ CEL, 4043/ ALU, CrNi/ RUTILE.
Step 4 Now, start welding.