12
EN
Instruction manual
TROUBLESHOOTING
ATTENTION! Before any work on the device itself, turn off the machine, disconnect it from
the mains supply, disconnect the gas hose from the gas cylinder and let the equipment cool
down.
Conventional trouble
Trouble reason
Remedy
Motor doesn’t start
∙
No electricity
∙
Check electrical outlet, check
mains cable, check fan. Repair or
replace if necessary
Piezo doesn’t ignite
∙
Electrode incorrectly adjusted
∙
Ignition electrode needs to be
adjusted: contact an Authorized IVT
Service Center
No gas at burner
∙
Insufficient gas supplied
∙
Gas valve is closed: open the
valve.
∙
Replace the gas cylinder
∙
Faulty gas valve
∙
Take the machine to an
Authorized Service Centre
∙
Gas hose or connection leaks
∙
Locate point of leak and repair
Burner
ignites,
flame
is
extinguished as soon as the gas
valve is released
∙
The thermoelement was not
warm enough
∙
Repeat ignition procedure,
while pressing in the gas valve
button (7)
∙
The safety thermostat switches
off
∙
Allow the heater to cool for a
few minutes and reignite
Burner goes out while in use
∙
Gas flow too high
∙
Have the pressure regulator
inspected and replaced if necessary
by an Authorized Service Center
∙
Insufficient gas supplied
∙
Replace the gas cylinder
∙
Air input too low
∙
Check the air inlet grill (4) and
clean. Inspect fan
If the problem cannot be remedied on the basis of the information above, please take the device to an authorized
IVT Service Center.
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualified and authorized IVT Service Center. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE.
