IVT CHS-1600, Operating/Safety Instructions Manual

Page: 5 / 52

17 21
18 20 19 23 22
5
Manual instruction | Electric chain saw
EN
consideration a hardhat or similar headgear should
be worn.
Wear safety glasses to protect your eyes. Helmets •
with integrated face protection are suitable.
Ensure that all spanners and other tools used •
to adjust the device have been removed to a safe
distance before turning on the device.
Worn or damaged parts must be duly changed •
in order to ensure safety.
The machine should be stored with its cutting •
parts unsheathed after use.
Operation
The operator should use the tool only for its •
intended purposes. Local conditions must be taken
into consideration.
Under no circumstances may the device be •
used in close proximity to other people, children or
animals.
The machine may not be used after the •
consumption of alcohol, narcotics or narcotic
anesthetics medication.
The tool shall be operated only by trained •
operators, or by those who can demonstrate their
ability to operate it properly. The tool is not for use
by children or adolescents.
Pay attention to what you are doing. Use a •
sensible approach to the job. Do not use the
machine if you cannot concentrate on the job.
Pay careful attention to the machine that is •
plugged in. Turn the saw off and remove your finger
from the trigger between individual cuts and when
changing location.
Under no circumstances should you take hold of •
the cutting part of the machine with your hands. do
not touch the moving saw chain with your hands.
The operator or the tool owner shall be liable •
for the possible accidents or damage that can be
caused to the third persons or their property.
Be aware, how the tool can be stopped quickly •
in case of danger.
The tool must never be operated with the •
damaged or dismantled safety guards.
While operating the tool always pay attention to •
the complete mounting of all grips and protective
guards. I Do not operate the tool that is not properly
assembled or underwent the unapproved changes
Always hold the machine with both hands whilst •
you are working. Mobile trunks and branch timber
should be fixed to a trestle using clamps or other
suitable tools.
Under no circumstances should the machine be •
held by its protective devices.
Do not allow cables to come within the working •
zone of the cutting part of the machine.
Always ensure there are solid supports and that •
balance is maintained when using the machine,
especially when using props or steps.
Pay careful attention to the surrounding •
environment in order to be able to timely react to a
possible dangerous situation.
Setup
Before any work on the machine itself,
pull the mains plug.
Protective gloves must be worn when
touching the chain.
Assembling the Chain and Guide Bar
17. Positioning pin
18. Chain tension bolt
19. Guide
20. Chain tension pin
21. Oil jet
22. Rotation direction symbol
23. Chain wheel
Place the machine on a level surface. •
Place saw chain (6) in the channel all around •
guide bar (7). Pay attention to the correct direction
of movement. Ensure that the direction of the chain
is the same as that of rotation direction symbol
(22).
Place the chain around chain wheel (23) and •
guide bar (7) in the same way, such that positioning
pin (17) and guide (19) fall into the longitudinal
aperture of guide bar (7) and chain tension pin (20)
falls into the hole provided for it on guide bar (7). If
required, turn chain tension bolt (18) to adjust pin
(20) to the aperture. Check that all parts are correctly