Iveco Stralis MY 2016, Body Builder Instructions

Page: 232 / 254

8
NEW STRALIS MY2016
‒
GUIDELINES FOR BODYBUILDERS
ADBLUE AND SCRT SYSTEM
6.4
MOVING ADBLUE SYSTEM COMPONENTS
–
Printed 692.68.697
–
5 Ed. - Base 03/2019
189106
Figure 3
1. AdBlue tank
2. Pumping module (SM)
3. Dosing module (DM)
4. Siphon
A < 1000 mm
B < 1000 mm
C > 0
S
≥
10 mm
Note Distance (A) is to be considered as fixed since the SM is integrated into the AdBlue tank.
In the diagram shown in the Figure 3, it can be seen that the pipes provide an adequate siphoning system in order to prevent any
damage due to possible AdBlue freezing.
The siphon should have an internal collection volume of 12 cm
3
and is to be located below the reference distance of the DM (for
example S = 10 mm).
Note After moving the AdBlue tank, contact the IVECO Service Network for the software upgrade connected to the management of the
relative system.
Moving the muffler
●
vertically:
Height increases of up to 100 mm are permitted compared to the original installation distance.
Since sufficient air circulation around the muffler must be ensured, there must be a distance of at least 80 mm between its
upper surface and the superstructure.
●
horizontally:
Retractions are permitted which do not involve changes in the original trend of the exhaust gas temperature in the pipes con-
necting to the engine.
The subsequent lengthening of this pipe must be carried out at the centre so as not to change the position of sensors A and B
in relation to the end of the pipe (see Figure 4).