SYNTHESIZED SETS
USER MANUAL
43
10. TROUBLESHOOTING
INCIDENT
SITUATION
ACTION
Check the condition of the key or that the
selector is in the ON position
Battery is correctly inserted
Neither of the transmitter indicators
and
light up
Ensure that the battery is charged or replace
it with a charged battery
Only the led
of the transmitter
light up
The battery is flat and should be replaced
with a charged battery
Check that the channel on the transmitter
and the receiver is the same
The led
on the
transmitter switch on, but
in the received the led
is off (not applicable to
GCFI versions)
In case the channel is not the same or if you
don’t know, keep activated the on push
button on the transmitter till the RX get on
(Max. 1 minute). Make it the nearest you can
to the RX
Both leds
and
of the
transmitter flash
Keyboard of transmitter is locked. Follow the
section “Looking the keyboard to unlock it
The led
of the transmitter flashes
A channel is active. Check that all actuators
of the transmitter are in the stand-by position
One of the leds of the transmitter
flashes quickly trice and then
pauses
A contact of the STOP BUTTON is faulty.
Contact the Technical Assistance Service
Led S2 of the Rx i son or flashes
and the stop relays are not locked
Fault in standard drivers or stop relays.
Contact the Technical Assistance Service
The set does
not start-up
Led S4 of the Rx generates quick
pulses
Fault of the eeprom. Check that it is inserted
in its socket in the RX. If it is and it still
doesn’t work, contact the Technical
Assistance Service
The led
switch on, but the RX is
not working
Keep active the Start push button on the
receiver till it starts (Max. 1 minute). Make it
the nearest you can to the RX
After making a
change of
channel, the
machine is not
working
The transmitter in pause the
receiver continues with the led
switched on
There are interferences in the new channel,
you must charge to another one. If you do
not receive the new channel on the receiver,
you must keep pressed on the transmitter
the Start pushbutton. (Max. 1 minute). Make
it the nearest you can to the RX.
Verify the battery’s charge
The transmitter
do not allow to
make the change
of frequencies
The lights
and
do not blink
alternately
Check the mode change of frequency
configured
Summary of Contents for BETON
Page 1: ...USER MANUAL SYNTHESIZED SETS...
Page 2: ......
