SYNTHESIZED SETS
USER MANUAL
25
ATTENTION:
AFTER INSTALLATION, CHECK THAT THE SET IS FIRMLY FASTENED
AND THAT IT DOES NOT SLIDE.
Due to the magnetic force of the magnets, follow these instructions to remove the set:
1. Loosen the screws M6 DIN 6921M6 (1) with a no.10 flat spanner.
2. Remove the receiver (2).
3. Pry with a flat screwdriver between the metal structure of the machine and the magnetic
fastening (3).
5.2. CONNECTING THE SET
It is recommended to connect the set with a standard multi-cable flexible hose used to connect push-
button boxes by cable. This hose will be connected to the set at one end, by means of the supplied
Itowa connector, and the other end will be connected to a multi-pole connector identical to the one
used by the machine to interconnect with a push-button box by cable. This enables the remote control
or the cable control to be interchanged simply by connecting or disconnecting the flexible hose.
ATTENTION:
THE HORN RELAY SHOULD NOT BE CONNECTED TO CONTROL ANY
OTHER MANOUVRE UNLESS OTHERWISE INDICATED.
The common manoeuvre lead should have a suitable diameter, not over 2.5 mm Ø or less than 1 mm
Ø, nor should two 0.75 mm Ø cables be placed. The common manoeuvre leds should not, under any
circumstances, be less than the diameter of the manoeuvre leads.
Summary of Contents for BETON
Page 1: ...USER MANUAL SYNTHESIZED SETS...
Page 2: ......
