SYNTHESIZED SETS
USER MANUAL
26
S1
S2
S3
S4
S1
S2
S3
S4
5.3. POWER SUPPLY OF THE RECEIVER
ATTENTION:
CONNECTIONS SHOULD BE MADE SO THAT WHEN GENERAL SWITCH IS
TURNED OFF, THE REMOTE CONTROL RECEIVER IS ALSO TURNED
OFF.
The receiver can be connected internally to three different voltages (230 Vac, 115 Vac, or 48 Vac),
except the BETON receiver that connects to a set voltage of 24 Vdc or 12 Vdc, depending on the
model. It is essential to ensure that the selector is in the correct position in accordance with the
voltage to be supplied to the receiver, before connecting the set. All receivers leave the factory with
the voltage pre-set at 115 Vac, but as a precautionary measure, it is advisable to check that the
voltage is correctly selected.
ATTENTION:
AS A SAFETY MEASURE, MAKE SURE THE UNIT IS EARTHED WITH THE
CORRESPONDING PIN OF THE CONNECTOR.
5.4. START-UP
Once the receiver is installed and when the general switch of the machine is turned on, the leds on
the front of the set will sequentially light up as a test. The function of each led changes depending on
the state of the receiver, but in this case, they only indicate the check control of the receiver.
Initial sequence
→
Intermediate sequence
→
Final sequence
Insert a charged battery. As regards Winner, the leds on the transmitter will blink sequentially as a
test. In case there should be a problem in the EEPROM of the transmitter, the led S1 would blink
intermittently.
S1
S2
S3
S4
UNIF0020
Summary of Contents for BETON
Page 1: ...USER MANUAL SYNTHESIZED SETS...
Page 2: ......
