Itel STL-SAT Changeover, User Manual

Page: 56 / 57

56 STL-SAT Changeover
© 2018 ITEL SNC
STS <space> TLM
STS <space> HW
ABOUT
INFO <space> TLM
INFO <space> HW
the command sent without argument provides the status of the audio inputs and the exchange
ALARM: if present, indicates that one or more alarm codes are active
TEST: If present, indicates that the message was sent from the "TestSend" function.
SWAP: if present, indicates that SwapChans mode is active.
Channels displayed as "main" and "back" on the setup program,
both on the display and on the SMS are the main and back channels used under conditions
normal, without taking into account SWAPCHANS status.
Mode: Audio + PI: Active swapping mode
Onair: STE: audio source on air. If "MUTED" is indicated, the output has been muted
as no valid source was found. "USRMUTED!" indicates that
the output has been muted at the user's request.
"USRBYPASS" indicates that the unit was placed in bypass on request
user, via SMS or GPIO port.
Main: FILT! : audio source for the main channel. An exclamation point indicates one
alarm condition.The display channel is always the master channel
regardless of SWAPCHANS status.
Back: STE: audio source for backup channel. The displayed channel is always there
the actual backup channel, regardless of SWAPCHANS state.
Pilot: 6.5: Pilot tone deviation in KHz
Qlt: 100: Incoming RDS signal quality
PI: 5432! : PI code of the incoming RDS signal. The exclamation point indicates one
alarm condition, in the specific case, the PI code detected is not
the same code generated by the internal coder.
MpxIn Lev: 92: peak level (%) of the incoming MPX signal (100% = 0dBm)
AudioIn L: 80: peak level (%) of audio signal, left channel (100% = 0dBm)
AudioIn R: 95 DRP! : peak level (%) of the audio signal, right channel (100% = 0dBm)
if 'DRP!' is displayed dropouts were detected on the L / R audio input
the command sent with the TLM argument provides the status of the external power supply and the battery
voltage
ALARM: if present, indicates that one or more alarm codes are active
Mode: Audio + PI: Active swapping mode
Onair: STE: audio source on air
Main: FILT! : audio source for the main channel. An exclamation point
indicates an alarm condition.
The displayed channel is always the actual master channel,
regardless of SWAPCHANS status.
Back: STE: audio source for backup channel.
The channel displayed is always the actual backup channel,
regardless of SWAPCHANS status.
Vbatt: 20.5: Battery voltage
Mains: OK: Network power status
the command sent with the HW topic provides information about the hardware / software versions of the
device
Fw: 2.0.0.0: firmware version
Sc: 201: subsys controller version