iseg NHR 20 20, Technical Documentation Manual

Page: 15 / 31

3.2.3. Menu Structure
Available Menu entries are:
Entry Subentry Subentry Content
CONTROL
VOLTAGE RAMP − Set voltage ramp speed
CURRENT RAMP − Set current ramp speed
CLEAR ALL EVENTS − Clear all events
SET KILL ENABLE − Set mode Kill Enable/Disable
DELAYED TRIP ACTION − Enable and define action for delayed trip
DELAYED TRIP TIME − Set time for delayed trip
CHANNEL SETUP
ALL CHANNELS POLARITY
POS Set polarity of channel
NEG
CHANNEL 0 OUTPUT-MODE Set output-mode of channel
CHANNEL 1
CHANNEL 2
CHANNEL 3
MODULE SETUP
MEASUREMENT
ADC SAMPLE RATE Set ADC sample rate
DIGITAL FILTER Set digital filter steps
COMMUNICATION
CAN BUS BITRATE Set CAN bus bitrate
CAN BUS ADDRESS Set CAN bus ID
CAN BUS STATUS
Show the CAN BUS Bitrate, Address,
Connect, RX and TX Information
DISPLAY POWER SAVE Set display power safe mode
RESET SET VALUES − Reset all set values
FACTORY RESET − Reset all settings to factory default
HARDWARE LIMITS
− − Shows hardware limits V
max
and I
max.
.
This screen is automatically shown, if the
hardware limits were changed.
SUPPLY / TEMP − − Shows supply voltages and temperature
INFO
− − Shows serial number,
firmware name and release,
nominal voltage and current
Table 4: Menu Structure
NHR – NIM standard High Voltage Power Supply | Last changed on: 25.11.2019 |
www.iseg-hv.com
15/31