Ironwood SLR305 | User Manual
19
When a workpiece is warped transverse, the convex side should
face down on the feed chain. If the convex side faces up, the saw
blade might become clamped by the workpiece, causing kickback.
Pressure roller
CORRECT
WRONG
When a workpiece is warped lengthwise, the convex side should
face up on the feed chain. If the convex side faces down, the
pressure rollers will not work smoothly, which can affect accuracy.
CORRECT
WRONG
7.4 Adjust Oil Supply to Feed Chain
The central lubrication system automatically applies oil at specific
intervals. The intervals can be adjusted according to conditions.
If the oil in the tank is below the minimum allowed value, the feed
chain will stop running automatically to prevent damage.
Oil flows from the central lubrication system to the oil distributor,
which then distributes oil to various points. The image below shows
the lubrication points and which line lubricates which point.
Brush (2)
Brush (3)
Chain rail (1)
Chain rail (2)
Brush (1)
Brush (1)
Brush (2)
Brush (3)
Chain rail (1)
Chain rail (2)
Oil distributor
Check every day before machine operation to ensure the oil reservoir
is full.
Before starting the machine, press the manual lubrication button
located on the front of the lubricator for 10-15 seconds to start the
flow of oil to the lubrication points. When starting the machine, make
sure the lubricator is in the intermittent OFF position to avoid over
lubrication due to repetitive starting.
NOTE: The oil pump in the central lubrication device is not intended
for continuous pumping for an extended time. Pressing the manual
lubrication button for more than 3 minutes may damage the oil
pump motor.
Oil inlet
Oil level
gauge
