Ironwood SLR305 | User Manual
10
3.6 Level
TOOLS REQUIRED:
• Bubble Level
• Adjustable wrench
Use a bubble level along the length and width of the tabletop surface
to check for level. Use an adjustable wrench to adjust the 4 leveling
screws on the lower end of the machine to level machine. After
leveling, be sure to retighten the leveling screws.
Be sure to level
the machine
3.7 Pre-Operation Cleaning
WaRninG
Use proper cleaning agents and methods described below. Do not
use gasoline or other petroleum-based solvents. There is a risk of
explosion and burning if these products are used. Serious personal
injury may occur.
Use a soft cloth and nonflammable degreasing agent, such as
Simple Green or other citrus-based cleaners to carefully clean off all
grease and rust preventative oils from all surfaces of the machine
and all lubricated parts. Do not use abrasive pads.
Caution
Use extreme care when cleaning the saw blade. It is very sharp.
Before installing the saw blade, clean its contact faces, saw arbor,
and lock washer with a clean cloth.
NOTE: Make sure the saw arbor flanges are completely clean when
installing the saw blade.
