Page 10 of 15
SLIDE-AWAY
Installation Guide
©Copyright 2021 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
11.
Attach Tub Brackets.
a) Slide M6x25 mm T-Bolts
(B8)
into
the underside of the side tracks.
b) Attach the L-bracket with the
long slot to the T-bolt, and loosely
secure with a M6 nut using a
10mm spanner. (
A11
,
A14
, or
A16
, depending on model)
c) Slide the vertical bracket into place
behind the horizontal bracket,
using the half-moon opening.
(
A11
,
A14
, or
A16
, depending on
model)
The top of this bracket should sit
on the underside of the tub’s lip.
If the tub liner needs to be cut
for access to the underside of
the lip, mark around the edge
of the brackets, cut liner, and
then continue.
d) Loosely Secure two brackets
together using the M8 bolts with
captive washer and spring washer
(
A7)
.
e) Insert a long bolt through the
bottom hole of the bracket, then
attach a rubber stopper to the
end (
A7)
. Drive until the rubber
stopper fixes hard against inside
face of tub.
f) Before final tightening, check
tracks are still square on tub.
g) Tighten all fasteners.
h) Attach snap-on plastic covers over
the mount brackets (
A13
or
A15
,
depending on model).
