www.irrobot.com
32
6.2 The robot is not moving
A. All Robots are not moving.
1) Check the main power is on.
If all powers are on, but robots are still not moving, go to next step.
2) Even all powers are on, but FND and LED are out, there are conductors on the
playground.
Check point
:
①
Turn off the main power switch on the control panel.
②
Disconnect the main AC cable.
③
Pull up the cover and clean the playground.
(Refer to page 30 C. )
④
Check 6 power supplying pins on the bottom of the robot.
⑤
Check the condition of power supplying pins.
If they are abnormal condition, it needs to replace.
⑥
Turn on the robot and put them on the playground.
⑦
Pull down the cover and connect AC cable.
⑧
Turn on the main power switch on the control panel.
⑨
Try to play game whether it works properly.
⑩
If they are still not moving, go to next step.
B. One of two robots is not moving.
1) Check the robot power switch is “On” in the bottom of the robot.
2) Check the number of the power supplying pin under the robot. It must be six.
3) All of six have to have proper tension and tightly fixed.
4) If the power supplying pin is missing, broken, or worn out, replace the pin immediately.
Also, it needs to check whether there is a missing or broken pin on the playground.
Make sure to remove it, otherwise it will make short-circuit.
5) The robot’s LED is out within 10 minutes after putting the robot out from the
playground, it may be discharged. Put the robot onto the playground and test it after
1~2 minutes.
7) If it’s still not working, replace the robot.
※
If you cannot fix the problem after above treats, check the main board
and contact your local dealer.
Summary of Contents for Marubot Football League 4 Players
Page 45: ......