Model2310 Ver.14.0
19
The heater is dry* – M027
There is not enough water in the heater to start it. The spa is shut down. After the problem has been resolved, you
must clear the message to restart heater start up. See ―Flow Related Checks‖ below.
The heater is too hot* – M030
One of the water temp sensors has detected 118°f (47.8°C) in the heater and the spa is shut down. You must clear
the
message when water is below 108°f (42.2°C). See ―Flow Related Checks‖ below.
Sensor-Related Messages
Sensors are out of sync – M015
The temperature sensors MAY be out of sync by 2°F or 3°F. Call for Service.
Sensors are out of sync -- Call for service* – M026
The temperature sensors ARE out of sync. The fault above has been established for at least 1 hour.
Call for Service.
Sensor A Fault, Senor B Fault – Sensor A: M031, Sensor B: M032
A temperature sensor or sensor circuit has failed. Call for Service.
Miscellaneous Messages
Communications error
The control panel is not receiving communication from the System. Call for Service.
Test software installed
The Control System is operating with test software. Call for Service.
°F or °C is replaced by °T
The Control System is in Test Mode. Call for Service.
System-Related Messages
Program memory failure* – M022
At Power-Up, the system has failed the Program Checksum Test. This indicates a problem with the firmware
(operation program) and requires a service call.
The clock has failed* – M020
Contact your dealer or service organization.
Hot fault – M035
A Pump Appears to have been Stuck ON when spa was last powered
POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer or service organization.
A pump may be stuck on – M034
Water may be overheated. POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer
or service organization.
Configuration error
(Spa will not Start Up)
Contact your dealer or service organization.
The settings have been reset
(Persistent Memory Error)
* – M021
Contact your dealer or service organization if this message appears on more than one power-up.
* This message can be reset from the topside panel.
Summary of Contents for Trinidad2200
