IQue Trinidad2200, Manual

Page: 17 / 55

Model2310 Ver.14.0
16
Cleanup
Cleanup Cycle Duration is not always enabled, so it may not appear. When it is available, set the length of
time Pump1 will run after each use. 0-4 hours are available.
Dolphin II and Dolphin III (Applies to RF Dolphin only)
When set to 0, no addressing is used. Use this setting for a Dolphin II or Dolphin III which is factory set for no
address by default. When set between 1 and 7, the number is the address. (See the Dolphin manual for
details.)
Color
Pressing the Select Button when Color is highlighted will cycle through 5 background colors available in the
control. They are Blue, Red, Purple,Grey,Green.
Language
Change the language displayed on the panel. Four language are available in the control they are English, French,
Spanish, German.
Information
System Information
The System Information Menu displays various settings and identification of the particular system. As each item
in the menu is highlighted, the detail for that item is displayed at the bottom of the screen.
Software ID (SSID)
Displays the software ID number for the System.
System Model
Displays the Model Number of the System.
Current Setup
Displays the currently selected Configuration Setup Number.
Configuration Signature
Displays the checksum for the system configuration file.
Heater Voltage (Feature not used on CE rated systems.)
Displays the operating voltage configured for the heater.
Heater Wattage as Configured in Software (CE Systems Only.)
Displays a heater kilowatt rating as programmed into the control system software (1-3 or 3-6).
Heater Type
Displays a heater type ID number.
Dip Switch Settings
Displays a number that represents the DIP switch positions of S1 on the main circuit board.
Panel Version
Displays a number of the software in the topside control panel
Jets

Jet1
To start pump1 (two speed) press ―Jet1‖ one time, the pump1 will work at low speed,
then press ―Jet1‖ again, the pump1 will work at high speed. The low speed will turn off
automatically after 15 minutes, and the high speed will turn off automatically after 15minutes.
Press the third time ―Jet1‖ the pump1 will stop.

Jet2 To start pump2 (two speed) press ―Jet2‖ one time, the pump2 will work at low speed,