iQTS244
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
CHANGING THE LOUVERS
Periodically the plastic louvers will need to be changed. The plastic louvers are made up of three sections. The two
front pieces are the same while the rear piece is different.
REMOVING THE LOUVERS
To change the louvers, remove the table and set it on
a secure surface with the wheels up. Each section of
plastic louver has a loop retainer that slips over a tab on
the table louvers. With light pressure lift up plastic loop
and push down to release. Repeat this process at each
end of each louver.
REPLACING THE LOUVERS
Start with the back plastic louver. With the table right
side up, line the plastic louvers up with table louvers
pushing down at 45° snapping into place.
10.4
DIFFERENT
SAME
