iQTS244
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
ADJUSTMENTS
11.2
Lay a 90° Square flat on the rolling table surface
with one side against the cutting fence (A).
Move the rolling table through the full motion front to
back. If the blade is not 90° to the cutting fence guide
rail will need adjustment.
Loosen the six rail mounting screws (X).
(Access screws from underneath left side rail.
VERSION 1 - WITH ADJUSTER CAM
Position the guide rail adjuster cam screws (Y) until
the blade is squared to the cutting fence (A) through
the full motion of the rolling table front to back.
When the guide rail is in correct position tighten
the six rail mounting screws (X).
VERSION 2 - WITHOUT ADJUSTER CAM
Adjust Rolling Table position until blade is squared to
the cutting fence (A) through the full motion of rolling
the table front and back.
INSIDE VIEW
x
x
x
x
x
x
Y
Y
OUTSIDE VIEW
x
x
x
x
x
x
Y
A
