iQTS244
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
WORK AREA SAFETY
• Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
• People and animals can distract you causing
you to lose control of the machine. For this
reason, always remain concentrated and
focused on the task.
• Do not use the machine in bad weather, such
as dense fog, heavy rain, strong wind, intense
cold, etc.
• Never start to work with the machine
before the working area is clear and you
have a stable work surface.
• Secure Work - use clamps or a vise to hold work
when practical. It is safer than using your hand
and it frees both hands to operate tool.
PERSONAL SAFETY
Never use the machine if you are fatigued, while under
the influence of alcohol or drugs, medication or anything
that could affect your vision, alertness, coordination
or judgement.
• Check that no tools or other objects have been
left lying on the machine.
• Never allow anyone else to use the machine
without proper training.
• Always shut off the machine during longer
work breaks.
• Never work alone, always ensure there is
another person close at hand.
• Learn how to use the machine and its controls
safely and learn to how to stop quickly.
Also learn to recognize the safety decals.
• Keep handles dry, clean and free from
oil and grease.
• Do not overreach. Keep proper footing and
balance at all times.
• Never stand on the machine.
SAFETY
Stand upright. Keep
distance between your
face and the cutting blade.
Place both hands on the
work piece as far away
from the cutting blade as
possible. If plunge function
is used, place one hand on
the cutting handle.
MACHINE USE AND CARE
• This machine is designed and intended for
cutting tile and stone. All other use is improper.
• Experience is very important when running
the machine. A skilled worker is highly
recommended.
• The machine is intended for use in industrial
applications by experienced operators.
• Check that the machine is assembled correctly
and do not show any signs of damage.
• Always perform daily maintenance before
starting the machine. See instructions in the
section “Maintenance”.
• Do not overload the machine. Overloading
can damage the machine.
• The blade shall be intended for the
material to be cut.
• If you are uncertain of what blade to use
contact your local service dealer.
• Keep tools sharp and clean in order
to enable safer work.
• Keep all parts in good working order and ensure
that all fixtures are properly tightened. Replace
all worn or damaged decals.
• Never leave the machine unsupervised with
the motor running.
• Feed the work piece against the rotation of
the blade only!
• Observe care when lifting. You are handling
heavy parts, which imply the risk of pinch
injuries or other injuries.
7.3
