iQTS244
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
ASSEMBLING THE TABLE EXTENSION
Remove the table extension from packaging. Insert the
extension shafts into the right side of rolling table.
With a Phillips screwdriver, install screws in each end of
extension shaft to secure
INSTALLING THE ROLLING TABLE
Put the remove table lock lever in the down position.
This allows the rolling table to be installed or removed.
Holding the table in front of you, on the left side of the
table line the 1st notch wheel roller with the guide rail.
Push the table along the guide rail until their 2nd and
3rd notch wheel rollers are on the guide rail.
Put the remove table lock lever in the up position.
The remove table lock lever should remain in the up
position for normal operation. The remove table lock
lever should only be put in the down position for table
removal and maintenance
IF THE REMOVE TABLE LOCK
LEVER IS LEFT IN THE DOWN
POSITION INADVERTENTLY THIS COULD CAUSE DAMAGE
AND/OR INJURY
WARNING!
ASSEMBLING
6.2
