FXO2
User Guide ver. 1.1
Autotranslation, no pics
2 SIP, 2xRJ45, 4xRJ11
Pre-version userguide
page 11 of 13
© IPshop ApS 2009
I:\FAQ\FXO2\userguide\FXO2_UG_EN.doc Ver. 1.1
address id the IP of the network gateway. Echo server is a standard service
implementing the ECHO protocol.
C
）
STUN
（
RFC 3489
）
When system support STUN then choice it and fill in the STUN server IP (or domain
name) address.
D
）
Relay Proxy
Relay proxy is Manufacturers NAT traversal technology which allow
FXO2 VoIP terminals to achieve anywhere of the complicated network
environments. It includes address, ports, user name, and password..
The RELAY can run in 3 kind of packaging mechanism:
Mode 1: The media use UDP packets and (or) encrypt with multiple UDP port;
Mode 2: The media use UDP packets and (or) encrypt with single UDP port;
Mode 3: The media use TCP packets and (or) encrypt (UDP over TCP).
3.5 Call divert
The two VoIP and PSTN channels both can be program to divert mode.
Forward Number (VoIP to PSTN)
When forward number (VoIP to PSTN) is filled, the VoIP incoming call will forward to the
number of the PSTN immediately. For the PSTN number “’
,
” is supported, it means
500mS delay between two digits.
Forward Password (VoIP to PSTN)
When the forward Password is filled, the call to PSTN needs input the “Password” before
the call is making. The call flow is: call the FXO2 -> hears the indication tone -> input the
password by press the keypad (by DTMF) -> get the PSTN dialing tone -> make call.
Forward Number (PSTN to VoIP)
When forward number (PSTN to VoIP) is filled, the PSTN incoming call will forward to the
number of the VoIP immediately. And when the VoIP side pickup the call will be
establish.
Forward Password (PSTN to VoIP)
When the forward Password is filled, the call to VoIP needs input the “Password” before
the call is making. The call flow is: call the FXO2 -> hears the indication tone -> input the
password by press the keypad (by DTMF) -> get the VoIP dialing tone -> make call.
3.6 Gain Settings…
The gain setting must be cautious to using. It was a hidden web page. If you want adjust
the VoIP Lines’s volume. Please rewrite the URL address to
http://xxx.xxx.xxx.xxx/default/en_US/
gain.html
and enter. The web browser will show up
a GAIN SETTINGS screen.
You can adjust the volume of the two PSTN Lines to different values. The range you can
adjust is from 5 to -5.
Note
: A too low or too high input gain will make DTMF detector insensitive.
3.7 Network Configurations
Click on Network Configuration in the left menu of the Configuration page and the
network
configurations screen will be displayed as below.
The Network Configurations screen allows user setup the IP addresses of the LAN and
PC port. User also can setup PC port to a DHCP server or working in Bridge mode.
3.7.1 LAN Port configurations
Choice one of the LAN configuration that meet your network environment, they are:
1
）
DHCP, 2
）
Static IP, 3
）
PPPoE.
1
）
DHCP
Choice DHCP when the network offering DHCP service.
2
）
Static IP
