FXO2
User Guide ver. 1.1
Autotranslation, no pics
2 SIP, 2xRJ45, 4xRJ11
Pre-version userguide
page 7 of 13
© IPshop ApS 2009
I:\FAQ\FXO2\userguide\FXO2_UG_EN.doc Ver. 1.1
f2: tone #2, 300-3000(Hz)
f3: tone #3, 300-3000(Hz)
f4: tone 34, 300-3000(Hz)
p1: attenuation index #1, 0~31(0=3dB, -1dB increments)
p2: attenuation index #2, 0~31(0=3dB, -1dB increments)
p3: attenuation index #3, 0~31(0=3dB, -1dB increments)
p4: attenuation index #4, 0~31(0=3dB, -1dB increments)
For example, you want add a tone as 450Hz and it is run 700 milliseconds and off 1000
milliseconds. You only add below parameters in corresponding option:
1,0,700,1000,0,0,0,0,450,0,0,0,20,0,0,0
3.4 Call Settings
Call setting let users program the parameters between gateway and the server(s).
3.4.1 H.323 Phone
Select the end point type to H.323 phone. There are three kinds of login mode can be
configured:
1
）
Single Configuration; 2
）
Configuration by line ; 3
）
Configuration by Group .
3.4.1.1 Single Configuration
In this mode, the two lines will login to the server with single number or prefix:
A. H.323 Phone Number
H.323 phone number: fill the login number (E164) here.
B. Gateway Prefix
If login with a Prefix method fill the prefix number (do not fill the Phone number)..
C. Display Name
Display name will display on the other VoIP party fill in the display name of the
gateway.
D. H.323 ID
If the system needs H.323ID for the Authenticate fill in the Authentication message.
E. Gatekeeper Address
Fill in the gatekeeper address with IP or domain name. If the registration port is not
1719 then add “
:
” and the port number. Like “192.168.1.70:8080”.
F. Enable Auth
If H.235 Authentication is needed click the “H.235 Auth” and fill the Authenticate
message
.
3.4.1.2 Configuration by Line
In the “
Config by line
” mode user can setup each of the two lines with difference
numbers
or prefixes. For advance using the each line can login difference server.
3.4.1.3 Configuration by Group
In the “
Config by Group
” mode user can setup each of the four lines with difference
groups. For advance using the each group can login difference server.
3.4.1.4 Advance Settings
Click “
Advance Settings
” in the H.323 menu, the configuration screen of advance
settings will be displayed as follows. User can modify all information of H.323 and the
preference of the media.
A
）
RAS Port
RAS Port is connected to an unreliable channel, which is used to convey the
registration, admissions, bandwidth change, and status messages between two H.323
entities.
B
）
Q.931 Port
（
Call Signaling Port
）
Call Signaling Port is connected to a reliable channel used to convey the call setup
and release messages between two H.323 endpoints.
