IPG YLR Series, User Manual

Page: 61 / 102

YLR-SERIES USER GUIDE
IPG PHOTONICS | COMPUTER INTERFACE / COMMANDS 47
C
C
O
O
D
D
E
E
D
D
E
E
S
S
C
C
R
R
I
I
P
P
T
T
I
I
O
O
N
N
E
E
X
X
A
A
M
M
P
P
L
L
E
E
S
S
SBAUD Set Baud Rate
– Followed by an integer number from 2 to 8
corresponding to baud rate from 1200 to 57600.
Sent:
“SBAUD 5”
Response:
“SBAUD: 5 | 9600”
SDC Set Diode Current
– Sets the diode current. The units are in
percent of maximum current. The setpoint must be below
100% and above the minimum current setpoint. The current
may also be set to 0. The response from the laser will be the
command echoed back, a delimiter of “: “, and then the current
setpoint for the laser. A value that is outside the acceptable
range will
receive a response of “ERR: Out of Range”.
Sent:
“SDC 34.2”
Response:
“SDC: 34.2”
(Current Setpoint is set to
34.2%)
Sent:
“SDC 104.2”
Response:
“ERR: Out of
Range”
(The setpoint is unchanged)
SMASK Set Subnet Mask
– Followed by a number in dot-decimal
notation sets the subnet mask for the laser.
Sent: “SMASK 255.0.0.0”
Response: “SMASK 255.0.0.0”
Response: “SMASK: Error!
Invalid Netmask!”
(Subnet Mask is unchanged)
SPRR
1
Set Pulse Repetition Rate - Sets the pulse repetition rate. The
units are in Hz. The pulse width and the duty cycle (dependent
on the pulse width and pulse repetition rate) must be within
the specified range. The response from the laser will be the
command echoed back, a delimiter of “: “, and then the pulse
repetition rate. A value that is outside the acceptable range will
receive a response of “ERR: Duty cycle too high“. Sent:
“SPRR 10”
Response:
“SPRR: 10”
(PRR is set to 10 Hz)
Sent:
“SPRR 100”
Response:
“ERR: Duty cycle
too high”
(The PRR is unchanged)
SPW
1
Set Pulse Width - Sets the pulse width. The units are in
milliseconds. The pulse width and the duty cycle (dependent
on the pulse width and pulse repetition rate) must be within
the specified range. The response from the laser will be the
command echoed back, a delimiter of “: “, and then the pulse
width. A value that is outside the acceptable range will receive
a response of “ERR: Out of Range” or “ERR: Duty cycle too
high“.
Sent: “SPW 5.5”
Response: “SPW: 5.5”
(Pulse Width is set to 5.5 ms)
Sent: “SDC 38”
Response: “ERR: Out of
Range”
(The pulse width is unchanged)
Sent: “SDC 8”
Re
sponse: “ERR: Duty
cycle too high”
(The pulse width is unchanged)
1
GATE MODE ONLY