DSC Panel Programming
See Supported Panels section on page 25. All Control Panels must
have a Phone Number in the Panel and an Account Number in the
Panel. As long as your Reporting Codes are in the Panel and is trans-
mitting in Contact ID it will send signals.
Programming when using TELCO (Recommended):
General Concept
Programming on DSC (BAT-CDMA-WIFI as Sole Communicator):
Sec
BAT as Sole Communicator
Code Summarization
301
Enter a Receiver Number
310
Enter Account Number
350
Enter ‘03’ to send Contact ID
Panel default is ‘04’, SIA
Programming ONLY when using the PC-Link to send Signals
(used when Tip/Ring cannot be utilized):
DSC Programming for
Communications - GSM Emulation:
If GSM is used, it must be in dialer capture mode.
Sec
BAT as
Sole Com-
municator
BAT as
Failover w/
Add’l Com-
munication
Device
BAT as Dual Re-
porting w/ Add’l
Communi-cation
Device
Code Summarization
015
Disable
Option 7
If GSM, Dis-
able Option
7 If Phone
Line, Enable
Option 7
f GSM, Disable
Option 7
If Phone Line, En-
able Option 7
Option 7 turns on/off tele-
phone line supervision.
167
Set ‘060’
Seconds
Set ‘060’
Seconds
Set ‘060’ Seconds
Sets T-Link acknowledge-
ment delay to 60 secs.
301
Set ‘CAAF’
Set ‘CAAF’
Set ‘CAAF’
‘CAAF’ has to be set for the
panel to send signals to the
PC-Link
302
N/A
N/A
Set ‘Central Sta-
tion Receiver #’
Second telephone number
goes here.
303
N/A
Set ‘Central
Station
Receiver #’
Set ‘Central Sta-
tion Receiver #’
This section is the tele-
phone backup of section
301.
350
Set ‘04’ /
‘04’
Set ‘04’ / ’03
for Contact
ID, 04 for SIA
FSK’ **
Set ‘04’ / ’03 for
Contact ID, 04 for
SIA FSK’ **
Format sent as either
contact ID (03), or SIA FSK
(04). The PC-Link / BAT can
ONLY receive signals via
SIA FSK (04).
Dual-Path Alarm Communicator - Installation Guide ...............................................
Page 16
Summary of Contents for BAT-CDMA-WIFI
Page 1: ...Rev 1 1...
Page 32: ...IPD CDMA WIFI IM 3 15...
