ipDatatel BAT-CDMA-WIFI, Installation Manual

Page: 10 / 32

Board Button Configuration
SW1 Button [located on the top left of the board]
There are several uses of the SW1 button on the device. Follow
the instructions below when ‘Tapping’ SW1 for the following various
features:
1 Tap - Device will go into WPS mode and should search for nearest
WPS activated Wi-Fi router in the area.
2 Taps – Device will indicate Wi-Fi signal strength [Device must be
paired to a Wi-Fi]
3 Taps – CDMA Module Service Provisioning (OTAP)
4 Taps – Device will force a firmware upgrade [Device must be paired
to a Wi-Fi router]
5 Taps - Device will factory reset and lose connection to any Wi-Fi it
was previously attached to.
Should any pairing issues occur, press the SW1 button 5 times to
factory reset and start the pairing process over.
Pre-Installation
Hardware Registration
Before installation of your BAT-CDMA-WIFI, it must be registered at
www.alarmdealer.com.
Here are the steps needed to register your hardware:
• Log in to www.alarmdealer.com with the dealer login information
that was emailed upon your initial company registration.
• Navigate to ‘Dealer Menu’->’Hardware Registration.’
• Enter the MAC address for the device you wish to register.
Adding the BAT-CDMA-WIFI to a Customer Account
After registering the hardware, the BAT-CDMA-WIFI must be added to
a Customer Account by following these steps:
• Log in to www.alarmdealer.com with the dealer login information
Dual-Path Alarm Communicator - Installation Guide ............................................... Page 10