14
STEAM LANCE
This accessory can be
applied directly to the
flexible.
Suitable for having a
powerful jet of steam
conveyed the nozzle
exit. Pay attention
when cleaning delicate
surfaces, start the
steam release
maintaining a minimum distance of 20-40cm and
then bring it closer depending on the desired result
and the treated surface.
JOINT
This accessory is necessary to use the
two brushes, RECTANGULAR and
TRIANGULAR.
Use this joint with the desired brush by
inserting it into its seat, making sure
that to hook it must be rotated of 90°
with respect to the working or vertical
position.
BRUSHES
These brushes are to
use with the
accessory STEAM
LANCE. They are
used to remove
resistant dirt and for
deep cleaning, even in
the corners or small
spaces. Choose the nylon or brass type according to
the surface to be treated.
MANTAINANCE
* Always remove the plug before
cleaning or carrying out operations
on the machine.
For the safety of the operator and to ensure an always
perfect performance, we recommend the following
checks and maintenance:
AFTER EVERY USE:
For a correct cleaning, it is advice to clean the machine
and its accessories with a clean cloth moistened only
with a few drops of water. Do not use alcohol or other
solvents, they may damage the plastics and
components.
To maintain efficient and easy to couple the
accessories, check the o-ring seal (
steam sealing
gaskets
) and possibly wet them with a little silicone
grease.
PERIODICALLY:
Periodically check that the power cord does not show
signs of wear or aging. If it is damaged, it is absolutely
necessary to get it replaced by specialized personnel
before being able to re-use the appliance again.
BOILER CLEANING
Clean the boiler in our authorized centers once a
year.
RINSE
: (for medium hard water)
It’s recommended at least every 100 hours of
operation or 6 months.
The machine must be cold or definitely discharged
from the steam pressure and the plug disconnected.
DISCHARGE: Open the safety cap (3), shake and
turn the machine upside down to let the water and
its limestone out. The machine must be turned as
shown in the picture below, by turning the front part
while keeping low the discharge zone (where the
cap is), or with a liquid suction and a tube of a
suitable diameter, draw the inside of the boiler itself.
BOILER CLEANING:
The boiler cleaning is recommended at least every
200 hours of operation or 12 months.
After having necessarily made the boiler exhaust
(see paragraph RINSE)
Dissolve in 1 liter of water about 15% of citric acid (if
in powder or granules, 150g of citric acid dissolved
for each liter of water).
(Alternatively it is possible to use 0,3 liter of water
with 0,7 liter vinegar).
Insert the prepared liquid in the refill tank of the
machine.
Let the machine to rest for 6-7 hours. (Att: do not let
inside the solution over the indicated time period to
avoid damaging the steel of the boiler)
With the machine cold, shake it well and make it
discharge completely following the instruction and
the picture of the paragraph DISCHARGE.
Now fill the boiler (see PREFACE) with clean water
and turn the machine one. Wait for it to heat.
Now, for about 10 minutes the steam supply will
smell of lemon given by the washing performed.
When the boiler cleaning is finished, restart the
machine following the instruction of paragraph
PREPARATION AND START TO USE.
