12
1
2
4
5
CONTROL PANEL
3
1 General switch
2 Display
3 Water-filling and safety cap
4 Steam adjustment knob
5 Connector block for hose
PREPARATION and START TO USE
ATTENTION! To fill or empty water from this
appliance, this has to be unplugged!
1 Open the safety closure cap of the boiler (3) by
turning it counterclockwise.
(
If while opening it steam gets out, wait until the
pressure drops out completely, just then go on
opening the cap)
2
FILLING
: With the help of a funnel and the
refilling bottle introduce about 1,5 liter of water
through the filling hole of the boiler (3)
-
Note
:
If the water available should be "very
hard"(>20°F), It is recommended the use of 50%
demineralized water or distilled water (this to avoid
excessive limestone formations.
ATTENTION: Do not add detergents, anti-limestone
solutions or essential oils in the water tank boiler, these
can cause irreparable damage to the boiler and circuits.
The manufacturer is not responsible for any damage
caused by improper use.
3
Close the cap (3) completely. Do not close too
strongly the cap in order not to damage the
gasket.
4
Choose the most suitable accessory for the
needed use and connected it to the
multifunction handle, by means of the
extension tubes, then insert the hose
connector as shown by the white arrow in the
picture.
2
3
1
6
5
Unroll the power cord and connect it to a
suitable electrical outlet on electrical power
system compliant with legal standards. (see
technical data pag. 3)
6
Push the
on/off
(1) switch. The display will
turn on showing that the machine is in
operation.
7
The display (2) will turn on and indicate the
temperature-pressure status of the machine,
when the machine is ready, it will visualize
“170”. (usually the machine needs around 7÷8
minutes to be ready).
8
Now to release steam through the handle of
the flexible, press the lever button (6). Now
use the brush or accessory in the surfaces to
be cleaned.
Attention:
it is recommended to perform the
first release of steam after the heating on a
container for about a minute, this is to collect
any condensate water generated in the initially
cold ducts.
