7
Quick Setup
Connect the
Cross-Member
and Legs
The cross-member
is reversible and can
be attached upside
down or from either
side. Fit the cross-
member snugly
into the rectangular
groove in one leg.
Align the holes in the
leg with the threaded
holes in the cross-member. Insert two 1-in (medium) Phillips screws
into the threaded holes. Leave them loose. Repeat this procedure for
the other leg. Tighten all four screws.
Insert the Media
Rollers
Insert the front media
roller pins into the
notches in the front
of each leg. There are
extra notches to ac-
commodate different
size rolls of media.
Find the matching
notches on the op-
posite leg to keep the
roller straight. Repeat
for rear media roller.
Figure 6.
Connect the cross-member.
Figure 7.
Insert the media rollers.
Cross-member
Roller
Notch
Tab
Step 3: Attach the Stand or Cradle
Place Cutter on the Stand
(I/S 85, 110 and 130 & SC-
40, and -48 models)
One person should
hold the cutter while
the other person posi-
tions it. Slide the tabs
on the bottom of the
cutter inside the top
of both legs. Make
sure that the holes in
the legs line up with
the threaded holes in
the tabs.
Figure 8.
Place cutter on stand.
