Preferred Installation –
Wood
Preferred Installation -
Concrete
Minimum aceptable N°1 –
Wall plate support
Minimum aceptable N°2 –
Wood floor
Minimum acceptable N°3 –
Concrete floor
Figure 2 -Locations of
acceptable screws
B
Hold the bracket in this position and use it as
a template to mark the holes based on the
configuration and type of construction, as
shown in step 3.
NOTE:
It is REQUIRED to use at least 2 screws to
mount the floor stand (one on each side
of the anti-tip floor stand).
Both must be
in the wall or on the floor.
Figure 2 indicates all acceptable mounting
configurations for the screws. Identify the
screw holes in the roll-away bracket for your
configuration.
2
HOW TO LOCATE THE ANTI-TIP
FLOOR SUPPORT (cont.)
Base support
in the
refrigerator
2 holes in
the wall
Refrigerator
left side
Floor - Concrete
(2 holes)
Floor - Wood
(2 holes)
130 mm
Floor
support
to be installed
Holes on
the right
INSTALLATION INSTRUCTIONS
2
A
HOW TO LOCATE THE ANTI-TIP
FLOOR SUPPORT
Inside the W space, where your refrigerator
will be located, make a small mark on the floor
attached to the back wall. This mark indicates
the desired location of the left side of the
refrigerator. From this mark measure 130 mm
to the right and place the anti-tip bracket. The
left edge of the holder must be 130 mm from
the left side of the refrigerator.
MATERIALS YOU MAY NEED
(not included)
Fastening screws ¼” (6.4mm) x1
½” (38mm) hex head for concrete-
and #10-16 x 1 ½” (38mm) hex
head screws for wood
Plugs 3/8” (9.5mm)
external diameter).
Only for anti-tip supports mounted on concrete.
Drill properly for the plugs.
7
