BEFORE REQUESTING A SERVICE…
Food is too near the air outlet
in the back of the refrigerator.
The refrigerator control is too
cold
• Keep the food away from the air outlet
• Move the refrigerator control to a warmer temperature set an
increase at a time.
Frozen food in the
refrigerator
Water comes out of the
dispenser The glass does not
remain underneath
Air may be contained in the
line system
• Hold the glass under the dispenser for 2-3 seconds. The time after the
dispenser button is released. The water can continue to be sufficient
after releasing the button being dispensed after the button is released
• Dispense water for at least 2 minutes to remove air from the water,
causing the water system to drip after being dispensed.
Water comes out of
the dispenser
The control display
shows tc
The Turbo Cool function is
activated
• See the controls manual section
Drawer clings or jams
when opening or
closing.
Drawer too full.
•
To open:
remove some of the products from the drawer when it opens
As much as possible Readjust any products left in the drawer and try to
open the drawer again.
To close:
Refit the products in the drawer or remove any products that
are on the edge of the drawer and close it.
Realignment of doors is
required
Refrigerator doors are
not even (on French
door models)
• Refer to the refrigerator door leveling section in the Owner's Manual.
Led Filter Status
indicator changes
to red
The filter expired
• Press the Filter Status button to display the remaining filter life. If the
screen shows 0%, the filter must be replaced. When the unit has
detected a new filter (a filter has been replaced), the Filter Status LED
will blink 3 times and then remain off to indicate that the filter was
successfully replaced
Problem
Possible Causes
What to do?
*Note:
“This product contains a light source of energy efficiency class F”.
In case of failure of the lamps it is necessary to call the technical service.
38
