Inventec N800G3, User Manual

Page: 12 / 258

About the Manual
2015-MNU-000023
iv
Electrical Safety
Motherboards, adapters, and disk drives are sensitive to static electricity discharge. These
devices are wrapped in antistatic bags to prevent this damage. Take the following
precautions:
Battery Replacement Safety
This server is provided with an internal Lithium battery or battery pack. There is a danger of
explosion and risk of personal injury if the battery is incorrectly replaced or mistreated.
For more information about battery replacement or proper disposal, contact an authorized
reseller or your authorized service provider.

Before installing or removing signal cables, ensure that the power cords for the system
unit and all attached devices are unplugged.

To prevent electric shock hazard, disconnect the power cable from the electrical outlet
before relocating the system.

When adding or removing any additional device to or from the system, ensure that the
power cords for those devices are unplugged before the signal cables are connected. If
possible, disconnect all power cords from the existing system before you add a device.

Use one hand, when possible, to connect or disconnect signal cables to prevent a
possible shock from touching two surfaces with different electrical potentials.

This product is equipped with a three-wire power cable and plug for user safety. Use the
power cable with a properly grounded electrical outlet to avoid electric shock.

If you have an antistatic wrist strap available, use it while handling the device.

Do not remove the device from the antistatic bag until you are ready to install the device in
the system unit.

With the device still in its antistatic bag, touch it to a metal frame of the system.

Grasp cards and boards by the edges. Hold drives by the frame. Avoid touching the solder
joints or pins.

If you need to lay the device down while it is out of the antistatic bag, lay it on the antistatic
bag. Before picking it up again, touch the antistatic bag and the metal frame of the system
unit at the same time.

Handle the devices carefully to prevent permanent damage.