SECTION 8—ARMS
Power Tiger™
62
Part No 1134839
Adjusting T-Arm Sockets
NOTE: For this procedure, refer to FIGURE 8.3.
1. Loosen, but DO NOT remove, the four hex screws and washers that secure T-arm
socket to T-arm clamp.
NOTE: The T-arm socket will disassemble if the four hex screws and washers are removed.
2. Slide the T-arm into the T-arm socket until the locking lever is in the slot in the T-arm
socket and an audible "click" is heard.
3. Squeeze the T-arm socket and the T-arm clamp together until the socket is flush with
the T-arm.
4. While holding the T-arm socket and the T-arm clamp together, tighten the four hex
screws and washers. Torque to 80-90 in-lbs.
5. Press in on the locking lever and lift the T-arm straight up and out of the T-arm socket.
6. Repeat STEPS 3-5, if necessary, until the T-arm slides in the T-arm socket as desired.
FIGURE 8.3
Adjusting T-Arm Sockets
Locking Lever
T-Arm Clamp
Hex Screws and Washer
T-Arm
Slot
T-Arm Socket
Hex Screws and
Washers
