SECTION 9—SEAT
Part No 1134839
65
Power Tiger™
Installing the Seat Frame onto the Base Frame
NOTE: For this procedure, refer to FIGURE 9.1 on page 66.
1. Turn the plungers located on the underside of the base frame plate until an audible
click is heard. See Detail "A".
2. Visually inspect the base frame plate to ensure the locking buttons protrude all the
way through the plate.
3. Place seat frame plate on base frame plate depressing the locking buttons.
4. Slide seat frame rearward.
WARNING
Ensure both sides of seat frame plate are underneath the locking channels of the
base frame plate and the seat frame is securely locked in place before using the
wheelchair. Otherwise injury may result.
5. With both sides of seat frame plate underneath the locking channels of the base frame
plate, continue to slide until an audible click from both locking buttons is heard.
NOTE: If an audible click is not heard from both locking buttons, wiggle seat frame plate back and
forth until an audible click is heard. This will ensure the seat frame is locked into position.
WARNING
Make sure the detent balls of the quick-release pin are fully released before
operating the wheelchair.
The detent balls MUST be protruding past the top of the seat plate assembly for a
positive lock.
Keep detent balls clean.
6. Push in on the tip of the quick-release pin and reinstall in the seat/base frame plate
assembly. See Detail "A".
7. Pull down on quick-release pin to ensure positive lock.
8. Install the footrests. Refer to Installing/Removing Footrests on page 35.
9. Install joystick onto mounting bracket. Refer to Removing/Installing Joystick on
page 87.
10. If necessary, perform the following:
A. Unfold the back canes. Refer to Folding/Unfolding the Back Canes on page 33.
B. Install the T-arms. Refer to Installing/Removing T-Arms on page 38.
NOTE: If a seating system is being used on the wheelchair, refer to the seating system Owner's
Manual for installation and removal of the seating system.
C. Install the existing seating system onto the wheelchair, if so equipped.
D. Install the batteries. Refer to Removing/Installing Batteries From/Into Battery
Boxes on page 76.
