SECTION 6—WHEELCHAIR OPERATION
Power Tiger™
36
Part No 1134839
Adjusting Footrest Height
WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
60°, 70°, 70° MFX, 90°
NOTE: For this procedure, refer to FIGURE 6.6 on page 36.
1. Remove any accessory from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Installing/Removing Footrests on
page 35.
NOTE: Lay the footrest on a flat surface to
simplify this section.
3. Remove the mounting screw, washers
and locknut that secure the lower
footrest assembly to the upper footrest
support.
4. Reposition the lower footrest to the
desired height.
5. Reinstall the mounting screw, washers
and locknut that secure the lower
footrest assembly to the upper footrest
support and tighten securely.
6. Repeat STEPS 1-5
for the other footrest,
if necessary.
7. Reinstall the footrest(s) onto the
wheelchair. Refer to Installing/
Removing Footrests on page 35.
8. Reinstall any accessory onto the
footrest(s).
FIGURE 6.6
Adjusting Footrest Height -
60°, 70°, 70° MFX, 90°
60°
MFX, 70° Taper
NOTE: For this procedure, refer to FIGURE 6.7.
1. Remove any accessory from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Adjusting Footrest Height on
page 36.
NOTE: Lay the assembly on a flat surface to simplify this section.
Locknut
Lower
Footrest
Assembly
Washer
Mounting
Screw
Upper Footrest
Support
Washer
Locknut
Mounting
Tube
Washer
Mounting
Screw
90° Footrest
60°, 70° and
70° MFX
Footrests
