SECTION 12—ACCESSORIES
Lynx™L-3X
44
Part No. 1145807
SECTION 12—ACCESSORIES
WARNING
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and
remove key from ignition.
NOTE:
The
crutch/cane
holder,
safety
flag,
rear
mounted
basket
and
oxygen
holder
all
install
into
one
of
two
accessory
tubes.
More
than
one
accessory
may
be
installed
at
one
time
depending
on
accessories
installed.
Installing/Removing the Crutch/Cane Holder
WARNING
The installation of the crutch/cane holder onto the back of the scooter seat signifi-
cantly increases the length of the scooter. When turning the scooter or swiveling
the scooter seat, it is important to take note of this increased length - otherwise,
injury and/or damage to the surrounding property may result.
NOTE:
For
this
procedure,
refer
to
FIGURE 12.1.
Installing
1. Install
the
crutch/cane
holder
into
the
accessory
tube
located
on
the
back
of
the
seat.
2. Install
the
mounting
knob
to
secure
the
crutch/cane
holder
in
place.
Securely
tighten.
3. Align
the
slot
on
the
base
with
the
hook
on
the
crutch/cane
holder
and
slide
base
down
into
position.
Removing
1. Remove
the
crutch/cane
holder
from
the
accessory
tube.
2. Remove
the
mounting
knob
that
secures
the
crutch/cane
holder
in
place.
3. Remove
the
crutch/cane
holder
from
the
accessory
tube.
FIGURE 12.1
Installing/Removing the
Crutch/Cane Holder
Accessory
Tubes
Base
Hook
Crutch
Cane
Holder
Mounting
Knob
