SECTION 11—TRANSPORTING
Lynx™L-3X
42
Part No. 1145807
SECTION 11—TRANSPORTING
WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and
remove key from ignition.
DO NOT lift the scooter by the rear shroud - otherwise damage to the scooter may
occur.
Transporting the Scooter
NOTE:
For
this
procedure,
refer
to
FIGURE 11.1
on
page 43.
Disassembling
1. Turn
power
off
and
remove
the
key
from
the
ignition.
2. Remove
any
installed
accessories.
3. Remove
the
seat.
Refer
to
Removing/Installing
the
Seat
on
page 27.
4. Remove
the
batteries.
Refer
to
Removing/Installing
the
Batteries
on
page 35.
5. Disconnect
the
tiller
wiring
connector
from
the
controller
wiring
connector
(Detail
“A”).
6. Hold
the
seat
post
with
one
hand.
7. With
the
other
hand,
push
the
release
lever
to
the
rear
of
the
scooter
(Detail
“A”).
8. Lift
the
seat
post
to
separate
the
front
frame
assembly
from
the
rear
frame
assembly
pins.
9. Fold
tiller
down
to
lowest
locked
position.
Refer
to
Adjusting
the
Tiller
Angle
on
page 31.
Assembling
1. Unfold
tiller.
Refer
to
Adjusting
the
Tiller
Angle
on
page 31.
2. Position
the
rear
frame
between
the
curved
locking
brackets
of
the
front
frame
assembly.
3. Hold
the
seat
post
and
align
the
curved
locking
brackets
on
the
front
frame
assembly
with
the
rear
frame
assembly
pins.
4. While
holding
the
seat
post,
slowly
lower
the
front
frame
assembly
onto
the
rear
frame
assembly
pins
until
the
release
lever
locks.
5. Connect
the
tiller
wiring
connector
to
the
controller
wiring
connector.
