SECTION 10—BATTERIES
Lynx™L-3X
38
Part No. 1145807
Connecting
1. Install
battery
terminal
cap(s)
onto
battery
cable(s)
as
follows:
A. RED
battery
terminal
cap
onto
RED
battery
cable.
B. GREY
battery
terminal
cap
onto
BLACK
battery
cable.
WARNING
When connecting the battery cables to the batteries, the battery cables MUST be
connected to the battery terminals/posts as shown in FIGURE 10.3, otherwise
damage to the battery cable may result when installing battery terminal caps.
2. Connect
battery
cables
to
battery
terminals:
A. NEGATIVE
(
‐
)
BLACK
battery
cable
to
NEGATIVE
(
‐
)
battery
terminal/post.
B. POSITIVE
(+)
RED
battery
cable
to
POSITIVE
(+)
battery
terminal/post.
3. Secure
the
battery
cables
ring
terminal
to
the
battery
terminals,
BLACK
to
NEGATIVE
(
‐
)
and
red
to
POSITIVE
(+),
with
the
provided
mounting
bolt
and
locknut.
Securely
tighten.
4. Verify
all
battery
cables
ring
terminal
are
correctly
installed
and
securely
tightened.
5. Slide
terminal
caps
down
battery
cables
and
onto
battery
clamps.
6. Position
the
batteries
on
the
scooter.
Refer
to
Removing/Installing
the
Batteries
on
page 35.
NOTE:
New
Battery(ies)
MUST
be
fully
charged
before
using,
otherwise
the
life
of
the
battery(ies)
will
be
reduced.
7. If
necessary,
charge
the
battery(ies).
Refer
to
Charging
the
Batteries
on
page 40.
8. Install
the
rear
shroud.
Refer
to
Removing/Installing
the
Rear
Shroud
on
page 44.
9. Install
the
seat.
Refer
to
Removing/Installing
the
Seat
on
page 34.
