(187IO) MODEL ZS8220 & ZS8230 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 08/01/2012
187A
SAVE THESE INSTRUCTIONS
Page 15
English
OPERATION INSTRUCTIONS
OPER
A
TING INSTRUC
TIONS
IMPORTANT: To maximize the ozone output of the system, select a daily start
time, usually after 10:00am, when humidity is the lowest.
1. Turn on the filter pump.
2
.
Start up the unit:
Plug the power cord into the
electrical outlet and test the
GFCI/RCD (circuit breaker).
Switch on the unit. Flashing code “00”
appears on the electronic control
station’s LED, indicating that the unit is ready to be
programmed.
3. Set operating hours for Ozone & Saltwater system:
With code “00” flashing, press button to
set the desired operating hours. See the
“Operating Time Table” for the required
operating hours related to each pool size.
Pressing will increase the time from 01
to 12 hours maximum. If you have selected
too many hours keep pressing to repeat
the cycle. The built-in timer will now
activate your Ozone & Saltwater System,
at the same time each day, for the number of hours you have set.
NOTE:
The Ozone & Saltwater System will not operate if the filter pump is not
operating. Make sure to program your filter pump (or start it manually) for
operation beginning 5 minutes before the Ozone & Saltwater System and
finishing 15 minutes after the Ozone & Saltwater System.
4
.
Lock keypad controls:
With the desired hour value showing, press button until
you hear a “beep”. A green “WORKING” indicator on the
control panel will light up within a few seconds to indicate that
the Ozone & saltwater system has started chlorine-ozone
production. Locking the control buttons into this setting
prevents unauthorized changing of the operating cycle.
NOTE:
If you forget to lock the keypad controls, the system
will automatically lock it and start working 1 minute later.
5. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary.
P
ress button until you hear a “beep” to unlock the
keypad and the current programmed time will flash.
Repeat steps 3 to 4.
(1 to 12 hours max per cycle)