![background image](http://html1.mh-extra.com/html/intex/krystal-clear-zs8220/krystal-clear-zs8220_owners-manual_2081406024.webp)
(187IO) MODEL ZS8220 & ZS8230 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 08/01/2012
187A
SAVE THESE INSTRUCTIONS
Page 24
English
TROUBLESHOOTING GUIDE (continued)
1.
Filter pump not attached to
system and/or switch on.
2
. Circulation line is blocked.
3
. Incorrect inlet and outlet hose
direction.
4
. Scale on the flow sensor.
5
. Flow sensor cord is loose.
6
.
Inner timer conflict between
filter pump
and Ozone & saltwater system.
7
. Flow sensor failure.
1
. Dirt or scale on titanium plates.
2
. Low salt level / No salt.
3
. Electrolytic cell cord is loose.
4
. Possible electrolytic cell failure.
1
. High salt level.
1
. Display and all lights are off - the
system does not power up.
1
. Ozone generator assembly
failure.
•
Ensure filter pump is attached and
operating. See "Setup Instruction".
•
If your unit has plunger valves, ensure
that they are open.
•
Clear your filter cartridge and cell from
debris and dirt. See “Maintenance”.
•
Release all trapped air in the circulation
line. See the filter pump manual.
•
Check the direction of the inlet and the
outlet hose. Reverse the hoses if
necessary. See “Set Up Instructions”.
•
Clean the flow sensor, paying special
attention to the hinge. See
“Maintenance”.
•
Plug the flow sensor firmly into the flow
sensor receptacle.
•
Reset both timers on the filter pump and
Ozone & Saltwater System.
•
Contact Intex Service Center.
•
Remove the electrolytic cell for
inspection. Clean it if necessary.
See “Maintenance”.
•
Add salt. See “Salt & Pool Water
Volumes”.
•
Ensure that the cell cord is plugged
firmly into the cell housing receptacle.
•
Contact Intex Service Center. Replace
the cell if needed.
•
Partially drain the pool and refill it with
fresh water. See “Salt & Pool Water
Volumes”.
•
Household voltage is too high or too low
(
+
20%). Check the voltage is within the
range stated on the device housing.
•
Contact Intex Service Center.
•
Contact Intex Service Center
. Replace
the assembly following the relevant
instruction in maintenance section.
LED PANEL
CODE
PROBLEM
SOLUTION
LED Panel Code Flash & Alarm On (
NOTE
: Always turn off the power before cleaning and servicing).
TROUBLESHOOTING
GUIDE