![background image](http://html1.mh-extra.com/html/intex/krystal-clear-zs8220/krystal-clear-zs8220_owners-manual_2081406016.webp)
(187IO) MODEL ZS8220 & ZS8230 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 08/01/2012
187A
SAVE THESE INSTRUCTIONS
Page 16
English
OPER
A
TING INSTRUC
TIONS
7
.
Boost cycle
•
After a heavy rain or if the pool is dirty, press and hold “BOOST”
button for 5 seconds until the indicator lights up and the
LED display “80”. This indicates that the Ozone & saltwater
system has started ozone and more chlorine sanitizer
production. You can press and hold the “BOOST” button for
another 5 seconds until the indicator is off, which will cancel
the Boost cycle.
•
The boost operating hours is 8 times the amount of time programmed into the
system, i.e. if your Ozone & saltwater system operating time is 3 hours, the boost
procedure will run 8 x 3 = 24 hours. After boost procedure has been completed,
the system will automatically switch to the normal working mode.
•
Once the boost is operating, check whether the filter pump operating hours
have been set properly. For example, the boost operating time is 16 hours, the
filter pump should be set to run for 17 hours at least. Increase the filter pump
operating time if necessary.
Note:
If an Intex filter pump is attached to the system, set the pump switch to
on “I” position.
8
.
Test pool water regularly:
Test the pool water every week to maintain the proper sanitizer level.
It’s very important that the free chlorine is between 0.5-3 ppm.
9. Stand-by/power saving mode:
•
When the cycle ends, the green “SLEEP” indicator on the
control panel lights up and the LED display flashes “93”.
The system is now in Stand-By mode. After a while, it
shuts down and sets itself in a Power Saving mode. The
system will automatically turn itself back on in 24 hours,
starting its daily cycle of chlorine production.
•
The “SLEEP” indicator stays on, while the system is in the
Power Saving mode. The LED display however, goes blank
after 5 minutes. Press any button ( or ) to view the last
LED code.
OPERATION INSTRUCTIONS (continued)