120-00012
GasD 8000 Series User Manual
12/14/2020
29
2)
Position the rear panel so the top and side edges are aligned with the instrument
case as shown below in Figure 7-14. Secure with the panel screws.
NOTE:
The
screws should thread easily into the screw holes
. If there is any significant resistance
when threading the screws, STOP, back the screw out and re-align the panel holes
with the threaded holes. Forcing a misaligned screw into the threaded hole will
strip the threads.
3) Re-connect the terminal block to the connector socket (terminal screws on the top).
Press firmly into place.
4) Align the bezel with the rear of the instrument case and press the bezel back onto the
rear of the case as shown in Figure 7-15 below. Confirm that the bezel has fully
snapped into place on both sides by pressing firmly with the palm of your hand on
each side.
FIGURE 7-14
FIGURE 7-15