Interpack ET xtreme Series, Operations Manual & Parts List

Page: 25 / 81

25
R05
T
ROUBLESHOOTING
ET xtreme
® Tape Heads are fabricated with high quality components that provide trouble-free
operation for a long period of time. However, should a problem occur, we recommend that you
consult the following table. If the problem you encounter is not discussed in this table, call
Interpack Technical Support. (see page 2 of this document).
T
ROUBLE
P
OSSIBLE
C
AUSES
S
OLUTIONS
Tape does not cut cleanly. Blade needs to be replaced.
Knife compression spring too
weak or broken.
Increase pressure on
compression spring in
repuslvie pivot assembly.
One way clutch roller needs
adjusting. Replace blade. Refer to
preventive maintenance section
for details.
Replace Knife Arm Spring.
Refer to preventive
maintenance section for details.
Slightly increase the tension on
the one way clutched roller.
Front tape leg too short.
Generally, too much tension
on the application of the tape.
Tape threaded incorrectly.
Tape leg length misadjusted.
Follow corrective action in
“
Tape Flagging” section
below.
Check for proper tape threading
against threading diagram on
side plate of tape head.
Re-set front tape leg length.
Tape Leg
UUU
in the tape head
UUU
folds up on itself.
Strong air circulation (fan) is in
the vicinity.
Spring loaded finger is out of
position. Redirect airflow away from the
tape head.
Check compression spring
mobility.
Rear tape leg does not fit
tight on the box. (ripple
effect).
Main spring is not strong
enough.
Change for the stronger main
spring. (Part no. UPH1090).